 |
Backpack for GPS Equipment/Aluminum Frame — 8124-00-ORG
Features a heavy-duty free standing aluminum frame with SurLoc™ antenna pole extensions. 3 adjustable internal pockets, 2 side and 2 bottom egress openings for cables and four cable straps. Adjustable pockets included in 3 sizes. Additional pockets available. (18 x 15 x 3.5 in) 6.3 lbs. |
 |
Backpack for GPS or GIS Equipment — 8125-00-ORG
Heavy-duty, high-visibility nylon Cordura™. Adjustable internal pockets, lash points for tying down additional equipment and gear, padded adjustable shoulder straps and waist belt, anti-tipping frame, rain flap, retro-reflective tape. Cool mesh and foam back pad make this comfortable to carry. (20 x 8 x 4 in) 2.8 lbs. |
 |
Backpack for Robotics Equipment — 8134-00-GRN
Double-zipped top loading station compartment lined with rigid foam padding, 2 side pockets for cables, front battery pocket. Top Velcro rain flap closure, rain flaps on side pockets. The free-standing aluminum frame keeps the pack upright even when fully loaded. Comfortable padded belt with our new lumbar back support system, shoulder straps with all-point adjustment features, rubberized carrying strap. 1-3/8" yellow safety retroreflective stripes on all sides. (24.5 x 15 x 16 in) 8 lbs. |
 |
Bag for Carrying 36-inch Lath — 8100-00-XXX
Bag for Carrying 48-inch Lath — 8101-00-XXX
Hand loop, shoulder strap and outside pocket. 8" dia. |
 |
Bag, 25 mm Prism System — 8022-00-ORG
This bag is used to carry items in the 25 mm Prism Assembly (#6200-00-XXX) |
 |
Belt Case for Husky/Ranger-Style Data Collectors — 8142-01-ORG
Padded case designed to be worn on the belt. It protects Husky/Ranger-style data collectors. |
 |
Bucket Bag with Outside Pockets and Wire Flag Holder — 8097-00-ORG
Convenient carrying bag designed with 2 outside pockets with hook-and-loop closures and inside wire flag holder. Leather bottom adds to stability and strength. (10 x 15 in) |
 |
Bucket Bag with Single Outside Pocket — 8095-00-ORG
Convenient carrying bag includes outside pocket, hand axe loop and leather bottom. (10 x 15 in) |
 |
Camcorder Battery Case — 8015-01-FLY
Holds long camcorder batteries, easily and securely attaches to the pole with a metal clamp and sturdy strap. |
 |
Case for Recon — 8240-00-ORG
This Cordura™ case is designed for the Recon collector. Belt loop and removable shoulder strap, outside pocket for small accessories.
(1 x 3.25 x 6.5 in)
Case for Recon w/CF Cap — 8240-10-ORG
This Cordura™ case designed for the Recon with compact flash cap installed. Belt loop and removable shoulder strap, outside pocket for small accessories. (1 x 3.25 x 9 in) |
 |
Case for Tribrach — 8071-00-ORG
This case is designed to carry a single tribrach. (6 x 6 x 2.5 in) |
 |
Cell Phone Pole Case — 8143-20-FLY
This new case from SECO holds all popular cell phones. This setup is used with GPS systems using GSM phone links. The clear cover on the case allows easy viewing of the phone display. Top flap allows for easy access to phone and can be left open for phone models with extendable antennas. Bottom flap allows for cable egress. Metal clamp easily attaches to the pole. |
 |
Direct Elevation Rod Case — 8166-00-ORG
Orange nylon Cordura™, reinforced bottom, front pocket for sensor bracket, shoulder strap.
 |
 |
Extra Long Bag for Stakes — 8092-00-XXX
Outside pockets for holding tools and supplies, adjustable shoulder strap, brass grommet drain holes at both ends. Used to carry 24-inch wood stakes and iron rebar. (25 x 8 x 12 in)
Extra Long Bag for Stakes and Hubs — 8096-00-XXX
Outside pockets for holding tools and supplies, adjustable shoulder strap, brass grommet drain holes at both ends. Used to carry 24-inch wood stakes with a partition down the middle to separate stakes and hubs. (25 x 8 x 12 in) |
 |
Field Case for Total Station/Alum. Frame/Front Load — 8122-00-ORG
Heavy-duty field case used to replace the hard case that comes with a total station. Orange, water-resistant nylon Cordura™, 2" foam padding on all sides. Works as backpack for most total stations. Inside dimensions: 6.5 x 7.5 x 17 in. Loads from the front, aluminum frame, compartment for accessories. |
 |
Field Case for Total Station/Aluminum Frame/Top Loading — 8123-00-ORG
Heavy-duty field case is used to replace the hard case that comes with a total station. Constructed from orange, water-resistant nylon Cordura™, 2" foam padding on all sides. Works as backpack for most total stations. Inside dimensions: 6.5 x 7.5 x 17 in. Loads from top, aluminum frame, compartment for accessories. |
 |
Field Case for Total Station/Front Loading — 8120-00-ORG
Heavy-duty field case used to replace the hard case that comes with a total station. Orange, water-resistant nylon Cordura™, 2" foam padding on all sides. Works as backpack for most total stations. Inside dimensions: 6.5 x 7.5 x 17 in. Loads from the front, compartment for accessories. |
 |
Field Case for Total Station / Top Loading — 8121-00-ORG
Heavy-duty field case used to replace the hard case that comes with a total station. Orange, water-resistant nylon Cordura™ and 2-inch foam padding on all sides. Works as backpack for most total stations. Inside dimensions: 6.5 x 7.5 x 17 in. Loads from the top, compartment for accessories. |
 |
Flagging Dispenser — 8025-00-ORG
Holds 4 rolls of flagging tape. Belt strap allows flagging dispenser to be carried around the waist or over the shoulder. |
 |
GPS Rover Rod Carrying Case — 8162-00-ORG
Designed to protect the rods during transportation or storage.
 |
 |
Hand Level Case — 8030-00-ORG
Padded nylon Cordura™. A belt loop on the back for convenience. |
 |
Heavy-Duty GPS Tripod Bag — 8154-12-ORG
Make sure your heavy-duty SECO GPS Tripod is protected in this extra-tough Tripod Bag. This bag features heavy-duty Cordura™ material and Rhinotek® end pieces for superior strength and longevity. Measures: 8 in I.D. x 56 in length. |
 |
Heavy-Duty Lath Carrier — 8102-01-ORG
This new SECO carrier can hold up to 50 lath. It can handle rebar too! This 1000 denier Cordura™™ bag has a thick, reinforced bottom of leather and the advanced Rhinotek abrasive-resistant material. The exterior features a hammer loop, paint can holder, marker pen slots and a pocket for miscellaneous gear. |
 |
Lath Carrier — 8102-00-ORG
The lath carrier is 33 inches long with two handle straps. It carries up to 50 lath. |
 |
Map Holster — 8083-00-ORG
Here is an easy way to access your maps. The 18-inch-long map holster can be worn on the belt or strapped to the lower leg with snap buckles. The three-inch diameter top opening is held open by internal wire. It's made from heavy-duty orange nylon Cordura™™ and a leather bottom. |
 |
Monster Gear Bag — 8106-10-ORG
The SECO Monster Gear Bag is built to carry a huge load. As with all SECO products, this product is hand-built by trained craftspeople with the finest materials available. This bag measures a whopping 30 x 14 x 20 in |
 |
Padded System Bag/Long — 8157-01-ORG
External and internal side pockets hold a prism with pole, bipod, controller and radio.
(58" long with 6" O.D.)
Padded System Bag/Short — 8157-00-ORG
External and internal side pockets hold a prism with pole, bipod, controller and radio.
(46" long with 6" O.D.) |
 |
Prism Bag for Jumbo Triple Prism Assembly — 8081-00-XXX
The jumbo triple prism bag is designed to carry one triple prism assembly with targets or tribrachs.
(9 x 9 x 5 in)
Prism Bag for Single Prism Assembly — 8070-00-XXX
This single prism bag is designed to carry one single prism assembly.
(7 x 5 x 2.5 in)
Prism Bag for Triple Prism Assembly — 8080-00-XXX
This triple prism bag is designed to carry one triple prism assembly.
(9 x 7 x 2.5 in)
Prism Bag, Extra Tall for Vertical Triple Prism Assembly — 8130-00-XXX
This case is designed to carry vertical triple prism assemblies.
(15 x 7 x 2.5 in) |
 |
Prism Pole Hard Shell Case — 8160-20-XXX
The heavy-duty material-covered tube holds one- or two-section poles or rods. It measures 65 inches in length. Use it to protect and carry your pole or rod. It's also great for shipping! |
| |
Prism Pole or Range Pole Protective Bag — 8170-00-ORG
Protect your prism or range pole from dirt and moisture.Prism Pole Tripod Bag — 8180-00-ORG
The prism pole tripod bag holds a prism pole with a tripod attached.
The 60-inch long bag has a fold-over flap and is made from orange nylon Cordura™ |
 |
Spray Can Holder — 8098-00-XXX
This spray can holder is constructed of heavy duty nylon Cordura™ and a nylon webbing belt loop. It holds paint can on hip for easy and convenient access. |
 |
Stake Bag — 8090-00-XXX
This stake bag is used to hold 18-inch wood survey stakes and/or iron rebar.
Stakes and Hubs Bag — 8091-00-XXX
This stake bag is used to carry 18-inch wood survey stakes. A convenient partition down the middle of the bag separates stakes and hubs.
These SECO stake bags features outside pockets for holding tools and supplies and an adjustable shoulder strap. There are brass grommet drain holes at both ends. (19 x 8 x 12 in.) |
 |
Super Jumbo Padded Bag — 8082-00-XXX
This new bag is designed specifically to hold a tilting single prism with tribrach adapter and optical plummet tribrach, or the SECO 6341-00 Tilting Triple Prism Assembly with Target
Outside dimensions: 13.5 x 13.5 x 7 inches. |
 |
Surveyors Gear Bag — 8106-00-ORG
This bag is excellent for carrying surveying accessories, clothing, and other miscellaneous gear. It measures 27 x 11 x 11 in. It's made from heavy-duty water resistant polyester. |
 |
Tool Pouch — 8046-00-ORG
The tool pouch features an 11 x 7-inch main compartment plus a 6 x 4-inch (15 x 10-cm) pouch for spikes and nails. It also has slots for crayons and markers, plus a loop for axes or hammers. |
 |
Tripod Bag: GPS Antenna Tripod/Collapsible Height Center Staff — 8154-00-GRN
Use with the #5119-00-XXX tripod or other conventional tripods.
Tripod Bag: GPS Antenna Tripod/Fixed Height Center Tripod — 8153-00-GRN
Use with the #5115-00-XXX Tripod.
GPS tripod bags are designed to carry the tripod without the point on the center pole to prevent damage to the pole. The bag features a full length heavy-duty zipper. |
 |
Tripod Bag: Instrument Tripod — 8150-00-ORG
The SECO Instrument Tripod Bag holds all major brands of aluminum and wooden tripods. It's made of heavy-duty nylon Cordura™, has a leather bottom, and pull string ties at the top. |
 |
Wire Stake Bag for Carrying 21-inch Wire Stake Flags — 8093-00-ORG
Wire Stake Bag for Carrying 30-inch Wire Stake Flags — 8094-00-ORG
Convenient bag for carrying wire stake flags. |
